The Saudi directory for PPF & ceramic coating15,000+ Google impressions and visits in the last 30 daysmore than 800 shops in 42 cities800+ shop page views300+ customers contacted shops directly500+ searches in the directory×9 growth in Google impressions on the month before

Dark patches and streaks after ceramic coating (high spots): causes and fixes

Last reviewed: · 3 min read

Short answer: a high spot is an area where too much coating was applied and not wiped off properly before it set. It looks like a dark shadow or rainbow streaks. Caught within minutes or a few hours, it wipes away easily. Once the coating has cured, it only comes off by lightly polishing the area and then recoating it, which is a job for the shop.

What they look like

  • A darker patch than the surrounding paint, as if there is an oily film on it.
  • Rainbow-coloured streaks, especially on dark colours.
  • Wipe marks running in one direction.
  • They show up most in sunlight or strong light, viewed at an angle.

Typical places: doors and other vertical panels, under the mirrors, and around the handles. These are the areas that are hardest for the installer to see while working.

Why they happen

The coating is applied to a small section, left for a short time, and the excess is wiped off. If:

  • too much was applied,
  • or the wipe was late and the heat made it set fast,
  • or the shop's lighting does not show vertical panels clearly,

then excess stays on the surface and cures as a thicker layer. Saudi heat speeds up curing, so the shop should work in a shaded, air-conditioned space.

What to do if you see one

At pickup

Check the car in sunlight or with a phone torch, walk around it, and look at each panel at an angle. If you find a patch, point it out while you are still there. In the first hours, the installer can put a little coating on the patch and wipe it, which dissolves and levels it.

Days later

Do not try to rub it off hard or with strong products. The coating hardens over several days, and rubbing can scratch the paint. Photograph it and go back to the shop.

How the shop fixes it

  1. Light polishing of the area until the patch is gone. This removes the coating there.
  2. Wiping and preparing the area.
  3. Recoating the polished area, because polishing removed the protection there.

This is an installation fault, and a serious shop fixes it at no charge.

Is it harmful?

It is a cosmetic problem more than damage. The paint underneath is fine. But the patch will not fade on its own until the coating wears down, which takes years. So do not wait for it to disappear.

How to avoid high spots

  • Ask the shop: do you work in an air-conditioned space with strong lighting?
  • Ask for a final check under the lights with you before pickup.
  • Give yourself enough time at pickup. Do not collect the car at night in a dark car park.
  • Read the questions to ask before choosing a shop.

Other marks that look similar

  • Water spots: white rings from water that dried on the surface. Usually removed by washing or a dedicated product.
  • Bird droppings or insects that left a mark.
  • Areas that were not polished well before coating, showing circular scratches.

If you are not sure, the shop can tell them apart quickly under the lights.

Bottom line

High spots are a small, simple fault if caught early. Check at pickup, and if you miss one, go back to the shop rather than trying to fix it yourself.

See ceramic coating shops in your city.

More guides

Recently added