How long does PPF installation take? The steps, and what to prepare
Many owners are surprised when a shop asks for the car for more than a day. The reason is that a proper installation is mostly preparation; the film itself is the last step. This is what happens, in order.
1. Wash and deep clean
The car is washed thoroughly, then whatever washing leaves behind is removed: tar, insect residue and iron particles. Anything left on the surface is trapped under the film and stays visible.
2. Paint inspection and correction
The film is clear, so whatever is under it shows through. Swirl marks and water spots are polished out before fitting. If there is a deep stone chip or a freshly repainted panel, the shop should tell you before starting.
Ask: is polishing included, and how many stages?
3. Cutting the film
There are two methods, and each shop has its own way:
- Computer-cut: the film is cut to your car's pattern before it touches the car. No blade goes near the paint.
- Hand-cut on the car: the film is laid as a larger piece, trimmed and wrapped around the edges. In skilled hands it covers edges more completely; the risk is the blade being close to the paint.
Ask: which method do you use, and are the edges wrapped or cut short of the edge?
4. Fitting
The installer sprays a solution on the panel and the film so it can be moved into position, then pushes the solution out with a squeegee from the centre to the edges. This step needs a closed, clean bay with strong lighting, because any dust that gets in at this point stays under the film.
5. Edges and final inspection
Edges are wrapped and pressed down, and the car is checked under the lights panel by panel. Any obvious air bubble or speck of dirt is fixed before handover.
6. Curing
A little moisture remains under the film after fitting. It leaves by itself over several days and shows as slight haze or small water bubbles. That is normal. In humid cities such as Jeddah and Dammam it takes longer than in Riyadh.
How many days?
It varies between shops and with the condition of the paint, but as a general idea:
- High-impact areas or a partial front: usually the same day.
- Full front: one to two days.
- Full car: several days, more if the paint needs correction.
If a shop promises a full car in a few hours, ask how. Extra speed usually comes out of the preparation or the edges.
What to prepare before the appointment
- Empty the car of your belongings.
- Tell the shop about any repainted or repaired panel, and when it was painted.
- Agree in writing on: the exact film name, the panels covered, what the polishing includes, and the warranty length and who provides it.
- Arrange your transport for the days the car is with them.
After collection
Do not wash it for the first week, do not press on the bubbles, and go back to the shop if anything remains after two or three weeks. Details are in the aftercare guide, and the handover checklist is in the installation check guide.
Ready to book? See PPF shops in your city.







